Products:
Stamp Set:
Layers of Beauty
Ink:
VersaMark
Reinkers:
Balmy Blue
Watercolor
pencils: Flirty Flamingo, Granny Apple Green, Daffodil Delight and Pecan Pie
Paper: Basic
White and Balmy Blue
Accessories:
Stamp Cut and Emboss machine, Layers of Beauty dies, Foursquare decorative
masks (retiring end of this month), Shimmery White Embossing Paste, F clear
block, Palette Knives, Silicone craft sheet, Water Painters, Silver embossing
powder, Heat tool, Tombo multi purpose glue, Stampin’ dimensionals, Paper
trimmer, Paper snips
Technique:
1. Tape down to Silicone mat a piece of
Basic White cardstock 5 ½” x 4 ¼”. Tape
mask from the Foursquare decorative masks down on top of cardstock.
2. Using a Palette knife put some paste
on the block. Add one drop of Balmy Blue reinker to paste and mix well. Spread
paste over mask scrapping off excess. I purposely left some areas blank to add
a distressed look. Set aside to dry.
3. Repeat on a piece of card stock 4 ½:
x 1 ½” Cut down to 4 ¼”x 1 ¼” once dry.
4. Stamp roses on on 4 ½” x 5 ½” piece of Basic White card stock using VersaMark ink and emboss with Silver embossing
powder using the heat tool. Stamp smallest rose (far right) on 2 ½” x 2” scrap
and emboss with Silver embossing powder.
5. Color roses with Flirty Flamingo
watercolor pencil, going darker towards center. Color Daisies with Daffodil
Delight pencil. Color daisy centers with Pecan pie. For the leaves I just added
pencil lines next to veins. Use a Water painter to smooth and spread out color
on flowers and leaves. Make sure to wipe off water painter brush between
colors.
6. Die cut image using large die from
the Layers of Beauty die set. You can
also die cut the small rose you will just need to cut off excess around bottom
of rose.
7. Cut panel once dry down to 5 ¼” x 4”
and adhere to Balmy blue card (8 ½” x 5 1/2” scored at 4 ¼”) using Tombo glue. (Note:
I start with a piece of cardstock slightly larger than I need so I can trim off
the part without paste where the paste was)
8. Stamp sentiment on scrap of Basic
white with Balmy Blue ink.
9. Pop up floral image and sentiment using
Stampin’ Dimensionals. Note: I made a small slit around one leaf to tuck my
sentiment behind, pulling the lower rose on top of sentiment.
10. Add a 4” x 5 ¼” panel to inside of
card. Trim panel with embossing paste to 1 ¼” x 4” and adhere to far left side
of card.
11. Add small rose to inside using Tombo Glue. Add additional sentiment if desired.
No comments:
Post a Comment